Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2018 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need Specifics on Replacing an 850 Starter 850

posted by  someone claiming to be bob on  Sun Jan 12 08:45 CST 2003 [RELATED]

There are 2 screws on each side. 2 into the top of the radiator, and 2 into the radiator support. Remove all 4, then pull back slightly and lift the plastic top piece off and slip out the cooling fan relay, EGR solenoid, etc, and put the plastic piece aside. Now you can access the top intercooler hose clamp. Remove the hose from the cooler and tie out of the way. Now, disconect the electric fan conections, and the fan/shroud will slip out as a unit. This clears the way to access the starter wiring and the bracket on the back side. 2 nuts on the back of the starter, 1 bolt into the block for the bracket.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need Specifics on Replacing an 850 Starter [850]
posted by  someone claiming to be Nate  on Sun Jan 12 05:29 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.