|
I have a few things to add to these helpful notes.
I just did this on and SC-815
1. The circut board is held down with sone (4 I think) metal clips through the board. Bend them to allow the board to slde over. You then have access to the bulb holders
2. I spent a long time trying to wind those bulbs on the holders, and after I was done they would not hold in place. They had become very brittle and lost some of thier important bits. I just cliped the wires very short and soldered them in place. Make sure you put the little blue bulb condoms on before you solder.
|