Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2023 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Water pump installation details 900 1993

posted by  spook on  Tue May 14 16:25 CST 2024
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:06 CST 2014
[RELATED]

Dear jd620,

Hope you're well and stay so!!! I use an hydraulic bottle jack and a short length of 1" x 2" lumber (the board) cut to length. I use gasket adhesive to secure the gasket to the pump. I then emplace the pump, using the bolts through the oblong holes. I snug, but don't tighten those bolts.

I then position the jack and the board, so that one end of the board is flat against the pump's bottom. I then use the jack very, very slowly to raise the pump, until I can start the bolts, that go through the round holes.

This method frees-up both hands, so I can use one to keep the pump pressed against the block while I get all of the bolts into position and tightened.

Water pump installation is most easily done by a human with three or four arms!!!!

Hope this helps,

Yours faithfully,

Spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Water pump installation details [900][1993]
posted by  B.B. subscriber  on Fri Jan 20 13:31 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.