Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2001 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Pulls to the left when breaking 900

posted by  Metallo on  Sat Mar 8 14:10 CST 2025
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Feb 29 21:03 CST 2012
[RELATED]

Hi Dave,

Today, I removed the control stay, which was easier than expected, meaning that unbolting was without any problem, as I see that Volvo used a white anti-seize.

Now, the problem: cleaning the conical housing to fit the bushings. I tried with a wire brush, so far just the front side, but still the bushing does not fit.

I measured the bushing part that should fit in and it is 32mm, the hole is 28mm, a big difference.

https://postimg.cc/dkXD4vnJ

https://postimg.cc/QKTCzPn1

https://postimg.cc/SYFknKDY

https://postimg.cc/vg8S3wT2

Also, it looks like there is groove in the middle of the hole.
I do have one of those step-drill conical bit, and the biggest diam is 32mm, maybe that could be a solution?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pulls to the left when breaking [900]
posted by  Metallo  on Sat Dec 21 09:37 CST 2024 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.