Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tie Rod (Strut) End Removal, 1993 940 900

posted by  Steve on  Wed Nov 23 15:37 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:16 CST 2014
[RELATED]

Rust belt= real bitch of a job. I ended up having to replace the inner tie rods due to inability to remove the outer ends from the inners. Fortunately, this is neither expensive nor time consuming (see the FAQ). Parts may be had from local suppliers such as NAPA. To get the tie rod end off the ball joint stud, use PB and some heat. Try using an ice cube on the warm stud to shrink it down and then pound the end off. If worse comes to worst, you are in the market for ball joints AND inner/outer tie rods.
--
See the 700/900 FAQ under 'Select Link' button on the top right.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tie Rod (Strut) End Removal, 1993 940 [900]
posted by  javalion subscriber  on Wed Nov 23 15:13 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.