Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Best connection method for generic Bosch O2 sensor wiring? 200 1992

posted by  Steve on  Sun May 14 01:37 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:16 CST 2014
[RELATED]

I imagine that a regular Radio Shack crimp connector would work fine. Make sure you get the wire doubled over inside so it has enough electrical contact when crimped. Smear silicone dielectric grease all over it before sliding shrink wrap tubing in place and sealing with heat.
--
See the 700/900 FAQ under 'Select Link' button on the top right.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Best connection method for generic Bosch O2 sensor wiring? [200][1992]
posted by  Herb Goltz  on Sat May 13 18:28 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.