Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2004 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

FRont ABS sensors and sensor wheels 700 1989

posted by  someone claiming to be Owen from Scotland on  Fri Jul 7 00:43 CST 2006 [RELATED]

Anyone know if it is possible to reduce the diameter of the front ABS sensor wheels (by removing rust with wire brush) to the point where they don't send a signal? I'm getting low speed pulsing of the pedal followed by the ABS lamp lighting after starting to drive. I've cleaned up the front ABS sensors once before which effected a cure for the same problem, but this time around it hasn't worked. Is there a design gap between the sensor wheel and the sensor pick-up that I could measure to determine if they are too far apart now?
Any advice gratefully received
Owen from Scotland
p.s. thanks to all for the great advice received in the past!








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    FRont ABS sensors and sensor wheels 700 1989

    posted by  jmars on  Thu Jul 13 02:06 CST 2006
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Wed Jan 2 02:18 CST 2008
    [RELATED]

    Had a similar problem with my 89 740 turbo wagon. Lite comming on after starting and some times pulsing.Turned out to be a bad power connection at the battery so be sure o look there too.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.