Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

'DID I FRY MY ECU' 200 1984

I recently replaced my engine wiring harness on my 1984 Volvo 240 GL and messed up by crossing two wires that had the same plug ends. One was suppose to go to the air idle control valve and the other to the throttle switch. My car started up just fine, but the idle was out of control. I disconnected the control valve and that brought the idle back to normal. I replaced the control valve and the throttle switch hoping that was the problem, but it was not. Any help here would be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED 'DID I FRY MY ECU' [200][1984]
posted by  JAWKNEEJ  on Sat Dec 30 05:09 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.