Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

AAAGH---$300 lesson in chasing vacuum leaks. CHECK the INTAKE MANIFOLD! 700

posted by  someone claiming to be sloopjohnb on  Tue Mar 18 11:30 CST 2008 [RELATED]

Ok, so the 740T was idling rough...pull #1 injector, no change.

Disconnect the amm and it ran better; ran better when amm reconnected. RPM's up to 1200 (900 in Drive) with amm reconnected. Throws 2-3-2 and 1-2-1 codes due to amm disconnect/reconnect. Smooth idle.

So WTF, O?
No vacuum leaks in hoses that I could find. Replaced the AMM with a known good one, no change in behavior. Even bled propane all around the engine, including injector O-rings and intake manifold/head.

Well, slap me upside the head...indy mechanic found vacuum leak due to bad intake manifold gasket. They checked out a few other things after replacing the intake manifold gasket and now it's katie bar the door when I step on it!! 18psi boost and good advance (no ping/retard) and rising rate fuel pressure regulator make some horsepower.

Still...I should have caught the intake manifold leak. D'Oh!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 AAAGH---$300 lesson in chasing vacuum leaks. CHECK the INTAKE MANIFOLD! [700]
posted by  someone claiming to be sloopjohnb  on Tue Mar 18 11:30 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.