Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Resonse... 200 1989

posted by  someone claiming to be adk blues on  Mon Mar 31 14:38 CST 2008 [RELATED]

I bought this kit from Horror Freight tools, after I saw it and a light bulb went on in my head (which happens infrequently):

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=46389

It has pushers and receivers which, amazingly, fit the Volvo control arms, torque rods, and panhard rods.

Basically, if you have a Bentley, with this kit and a few 1/2" impact sockets of the right diameters (again, HF cheapies work well), you can duplicate all of the press tooling shown. Parts from this kit can also be used to fabricate a TAB bushing removal/installation tool.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Has anyone here used a Scantech control arm from FCP? [200][1989]
posted by  245DogWaggin  on Mon Mar 31 13:22 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.