Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Info on B23F/B230F head swap-out please 200 1983

The older 398 head on my '83 with it's big coolant passages (BCP) caused the early demise of the head gasket. I am looking to replace it with a 530 head with it's small coolant passages (SCP). There are several later model 700/900 series Volvos in my local Pull-A-Part that could be possibilities for the replacement.
If the best candidate turns out to be one of these, how would I plug the hole where the rear-mounted distributor sits? I have not investigated this yet and want to be armed with sufficient knowledge when I hit the yard. Would this plug be something I could take from another junker or would it have to be a dealership part?
I am aware that I would also need to get the valve cover and accompanying gasket that goes with the replacement head. Thanks for any tips & info.
Regards,
Jim








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Info on B23F/B230F head swap-out please 200 1983

Hi,


The part which you wish to appropriate is available and very common.

http://www.fcpgroton.com/product-exec/product_id/3653/nm/1985_1993_Volvo_240_Rubber_Cam_Plug/category_id/125

Photobucket


Goatman







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.