Newbie here..




OK, so i had the car running and all was good, until


I parked it and I was siting through the gears just to check the linkage and i noticed that when i go from drive to park it would stall out for a sec then come back on, I tried it once again and and the car died! and wont start there was no spark form the coil so i went and bought a new coil and still nothing... what the heck could it be? I don't know if this has something to do with the tranny or what?
I have replaced the power stage, cap rotor, checked the neutral safety switch but I cant figure out why i still don't get spark? any help appreciated!

How about your RPM sensor? It is on the bellhousing, and when you change gears it will load up in different directions, causing motor movement. If the RPM sensor cable is deteriorated this movement could cause an interruption of signal.

If you get the car to start, try wiggling the sensor cable and see if you can make it stall.

Good luck!

P.S. If there is a lot of motor movement, check your motor and transmission mounts.