Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

clutch cable hole position in firewall 200 1989

posted by  greg_mustang on  Fri Jan 30 09:48 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

Hi all,

I have started converting my '89 240 from AW71 to an M47.
I used a doner car from a friend, took all the parts typical for this job, and also a new clutch, bearing, and cable, and a couple seals while I was there. The other car has now been junked.

I have installed the pedal assembly.

My next step is to drill the hole for the cable. I have found photos to show me the position, they are referenced from the left of a diamond shaped cap with two bolts on the firewall to the right of the master cylinder. Problem is on my car - I do not have this diamond shaped two bolt cover. The space to the right of the master cylinder is pretty much empty.

Can anyone provide me with a clear photo or diagram or measurement of where the hole is exactly? I want to do it from the engine firewall side, I have a right angle drill and hole saw bit for metal at the appropriate diameter, just need to X mark the spot!

Thanks in advance,
Greg Mustang
Montreal - Canada


--
Greg Mustang - www.volvoclassic.bravehost.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New clutch cable hole position in firewall [200][1989]
posted by  greg_mustang  on Fri Jan 30 09:48 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.