Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I need to get the rear carpet out fast!

posted by  will rehsper on  Mon Oct 19 05:57 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 3 14:55 CST 2012
[RELATED]

To get the whole carpet section out:

1. Front seats must come out. 13mm socket, 1/4" drive works fine. Two nuts up front, slide seat forward, then remove the plastic cover clipped to the outboard mounting point (prys off). Then you can get the two bolts in the back.

2. Center console. Philips head screwdriver to remove screw on either side of the cover. Couple of electrical connections there too.

3. Bolts into the driveshaft tunnel. 16mm socket to remove the two bolts, one on either side of the tunnel.

4. Black plastic pieces at the bottom of the door frames pull off.

5. You may need to remove a screw at each of the floor vents (directly under the front seats).
--
854 - 244 - Mini






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I need to get the rear carpet out fast!
posted by  someone claiming to be Oops!  on Mon Oct 19 05:38 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.