Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rad support 200 1986

posted by  Rhys on  Sat Aug 7 04:40 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Nov 20 10:22 CST 2012
[RELATED]

I think it's about six bolts if memory serves, to remove the rad support panel. Even the hood release can be left in place, and just swing it out of the way with it attached. Then the engine-trans just glides in. I also install the engine mounts complete, and drop the three studs through the crossmember, rather than messing with the angles.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installing engine: pain in the rear. [200][1986]
posted by  wolf_walker  on Sat Aug 7 04:28 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.