Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Crank pulley removal with head removed 120-130

posted by  dinomartino on  Sat May 7 06:13 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:43 CST 2014
[RELATED]

If you have access to bolts that'll fit the head bolt threads:
take piece of scrap wood small enough to fit into the piston bore sideways (so force is being applied across the grain, not along it). Then take a second, larger piece of scrap wood, drill holes so that it can be bolted to the block with the bolts, fasten it down to the block, and you should be good to go. No need to screw the pieces of wood together, I'd be worried about what that screw might scrape if the piece in the bore happens to split.

john
--
1989 245 233K / 1993 945 127K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crank pulley removal with head removed [120-130]
posted by  Amazon66  on Fri May 6 22:58 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.