Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Brief notes on blower motor replacement 200

uid 27's pic
posted by  Art Benstein on  Sun Aug 7 09:43 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Me too. VDO from FCP.

1. The aftermarket (MTC) resistor pack is complete crap. From the ceramic coating on the resistors, to the connector, right down to the quality of the crimps, there is nothing good about it. If you MUST buy the aftermarket resistor pack, snip the connector off and solder or crimp the original in it's place. You will have to do transplant surgery on it anyway, since the 12v and A/C lead must be transferred.

Everything you said I ran into as well except the resistor itself was OK.





fan job <<-- new pictorial

pulling dash first <<-- new pictorial

--
Art Benstein near Baltimore

If you tell the truth, you don't have to remember anything.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 Brief notes on blower motor replacement [200]
posted by  scorron subscriber  on Sat Aug 6 20:07 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.