Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

not getting fuel to injecters 200 1980

posted by  machine man on  Sat Jan 7 23:27 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:40 CST 2014
[RELATED]

Down under, the throttle there is a rubber bellows. Inside it, there is a flap plate.

As the engine draws in airflow, the flap raises to let gasoline flow to the injectors.

The injectors have to have some where in the neighborhood of 35 psi to open the injector nozzle. That is why the question for the amount was important from Goatman.

If the car has not run for some time, the fuel may have gummed up the fuel distributor that holds the flap. You may need to slip off the bellows and check to see if the disc/flap will lift up VERY easily. If you blow just a little bit of air under it, it should lift.

Anyway, I am guessing but it would be the first place to look for me.

Phil






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New not getting fuel to injecters [200][1980]
posted by  McFinley  on Sat Jan 7 17:33 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.