Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

SOLVED - Driveline knocking increases after new mount - why? 200 1993

posted by  derek uk on  Fri Jan 24 06:23 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:33 CST 2014
[RELATED]

Depending how much clearance you need you/the welder can probably cut nearly through the pipe from both sides front and rear of the cat and reweld them making a slight dog-leg. Would be best to drop it down for the finish welding though for the best job. Also, it's often possible to release the clamps and move the sections around a few degrees to change the alignment for extra clearance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveline knocking increases after new mount - why? [200][1993]
posted by  woodshavings  on Sun Jan 19 22:50 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.