Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Looking for a reliable OD intermediate housing gasket 200

posted by  ODGuru on  Sat May 24 08:38 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 18:52 CST 2014
[RELATED]

Did you replace the plastic crush seals under the top two nuts that hold the housings and brake ring together? That type of seal is a one use only.

An alternative if you do not have the crush seals is a copper washer that fits the recess on the case drilled to the 5/16 bolt size. Or a Nylon washer fitting the recess with a steel washer over.

I've torn a few of the thinner paper ones on install but never had them leak.

Duane






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Looking for a reliable OD intermediate housing gasket [200]
posted by  skiman26  on Fri May 23 20:17 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.