Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Time to change head gasket 900

uid 55's pic
posted by  john sargent on  Mon Oct 19 10:49 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

I don't undo the three nuts which hold the head pipe to the turbo wastegate housing. I undo the hard to reach nut from under the exhaust manifold, and put a floor jack under the head pipe, and lift it just a little. If you lift too much, you'll have to deal with the o-ring at the bottom of the turbo oil drain tube. With the intake manifold removed (of course), the head can be tilted up on the left side and slid up and over the sleeves which position the head gasket.

I don't undo the turbo oil supply line.
--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Time to change head gasket [900]
posted by  PA24 driver  on Sun Oct 18 08:03 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.