Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bill of materials 200 1993

uid 27's pic
posted by  Art Benstein on  Tue Dec 8 06:45 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

About 12.00 in 2001 dollars. If I recall correctly.

Seriously, google "unistrut" so you can get familiar with a strong and cheap method of creating a beam. Get familiar with the sizes and terms so you can visit your hardware store locally and use the lingo to find it or its alternate brand equivalent. It is in the electrical section, if there. Perhaps you might have to look up an electrical supply house, where electricians get their stuff.

Get a piece about 6 feet long. The deep variety is going to be stronger. While you are in the hardware store, also get a long threaded hook -- 5/16 or 3/8 material. Look for one that has 4-6" of thread on it and get some nuts and washers to fit. If you don't have any already, buy an 8' 2x4 cut in half to protect your fenders.






--
Art Benstein near Baltimore

http://cleanflametrap.com/oilpan/






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 cross fender engine lift [200][1993]
posted by  geof  on Mon Dec 7 23:46 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.