Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Looking for Brake Junction Procedure Advice 200

posted by  1pocket on  Sat Apr 30 15:11 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

its a messy job no matter what you try.

1. get a stick and press down on the brake pedal 1/4 way and lock the stick against the carpet so the pedal will not retract. this close the master plunger enough to keep the resevoir from emptying. pull the brake fuse so as not to burn out the brake light bulbs.

2. before you disconnect ANYTHING verify all 4 wheels caliper bleeders will open without snapping off. if good then disconnect the junction and reconnect and bleed

3. if any of the bleeders will not open and you can not get them to open add a caliper/s to your parts needs.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Looking for Brake Junction Procedure Advice [200]
posted by  1990Volvo240 subscriber  on Sat Apr 30 13:39 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.