Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to slide the loose, unclamped tailpipe from the 240GL Wagon, and to disconnect the muffler from its mount. 200 1986


How to remove the muffler from its hangers is not entirely obvious to me


The best way is not to pry the rubber pieces but to unscrew the pins from the body.

Here's the pin (one of two) by itself.





See the facets? Support the axle pipe per Art's suggestion. Then find the correct size open end wrench and remove the pin on the right side. You then should be able to drop the muffler enough to remove the hanger and then just pull it off the of the other pin.


--
'80 DL 2 door, '89 DL Wagon, '15 XC70 T6






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 How to slide the loose, unclamped tailpipe from the 240GL Wagon, and to disconnect the muffler from its mount. [200][1986]
posted by  XPEG_656  on Sun Mar 19 20:36 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.