Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2013 1800 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

M41 rebuild 1800 1969

I am rebuilding my m41, does anyone have a good bearing source in the US that handles all of the required bearings for this box? Thanks








  REPLY TO THIS MESSAGE    EDIT   PRINT   SAVE 

Hello,

I should have them all in stock.

Do you know which M41 you have, the early version with small rear mainshaft bearing and "D" overdrive, the intermediate version with the large rear bearing with a "J" overdrive or the late version with the large rear bearing, "J" overdrive and large cluster shaft?

I stock original SKF bearings for the mainshaft. I have all of the individual needle bearings used for the end of the mainshaft, for the cluster and if needed the caged needle bearing assemblies for the 1st, 2nd and 3rd gears on the mainshaft for the 4 speed section and the 3 bearings for both styles of O/Ds.

I also have stock synchros, shift dogs, shift dog springs, thrust washers and gasket sets for the 4 speed section and I have reseal kits for both styles of O/D.
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502
hiperformanceautoservice.com or oldvolvosonly.com



Mark this post as an answer to my question<- Use this feature to mark quality replies to your post.




<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.