Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Problem SOLVED! 200 1992

Good to hear that! You got your idle back!

The ON823 Darlington, made by Philips is unobtanium nowadays. It could only withstand 80V collector-emitter voltage (safety headroom for injector voltage back-spike). Bosch used this in my spare -934 ECU. In the -935 ECU that I'm currently using the component had been updated to BDX53C. This Darlington could withstand up to 100V (same for TIP122). Good news its still available at most online parts store. Bog standard caps with prescribed value is good enough for replacement. Using low ESR caps might get the LDO regulator into oscillation. And take care in desoldering the caps (transistors too) as the old copper traces might delaminate with undue heat.


Regards,
Amarin.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 245 correct idle after start but high after use [200][1992]
posted by  Grey245  on Sat Oct 3 02:51 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.