Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2003 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Help w/ HKS EVC II Installation 700

Hey all--

Today I tackle the task of replacing my G. Valve with an HKS EVC Electronic boost controller. So here's a question. Where is the best spot on the passenger-ish side of the car to run a 1/2" thick wiring harness through the firewall into the engine compartment? It needs to be relatively direct, as I don't have too much wire. I've used up all the grommets on the drivers side, and I wouldn't be able to fit this thick harness through anyway.

Any ideas?

Thanks much...
--








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Help w/ HKS EVC II Installation 700

Try pushing the firewall grommet completely through the firewall. Then work the HKS connector through it carefully while it has the additional flexibility of floating freely.

Philip Bradley








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Help w/ HKS EVC II Installation 700

That did it... Thanks Philip. :)

--







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.