Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

struts 200 1983

Hi all!
Planning on replacing all front bushings, engine and tranny mounts, tie rods and ends, and struts. My question is (my apologies if this happens to be a redundant question): As far as struts, what else do I need to check/replace? (spacers, bearings, etc..) Thanks in advance.
Denny








  REPLY TO THIS MESSAGE    PRINT   SAVE 

struts 200 1983

you can "rent" the needed tools from AutoZone, or similar. You acutally buy them then take them back for a refund when done. That's their idea, not my idea of some ploy.
--
'Most Improved Patroller of the Year' Blue Mountain Ski Patrol, Palmerton, PA








  REPLY TO THIS MESSAGE    PRINT   SAVE 

struts 200 1983

When I did my front end, I did the whole thing. That included ball joints and upper strut bearings. OEM Strut bearings are wery wery expensive so I got the cheapie $40 ones. Maybe I'll be sorry in 100K miles but that's 8 years down the road for me. Ball joints are generally cheap and easy to replace as long as you're going after the struts.

Bob
'82 intercooled turbowagon
A bunch of Amazons







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.