Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2012 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Clutch/Engine noise 200

I have a 1991 240. Here is the deal:

Vibration/winding noise when shifting 1-3 gears. Noise also occurs at high RPMs (i.e. using engine to slow car going down a hill). Starts always once car is warmed up. Seems okay when cold. 4th and 5th gear are fine 95% of the time. Clutch was replaced 2500 miles ago and the noise just started. It sounds like metal vibrating, but is somehow tied to shifting. Clutch does not slip or squeal, or anything like that. Its very frustrating. Nothing seems loose. Noise occurs when the clutch is pushed in, quiet when released. Any ideas anyone?

Thanks,

GEOFF SUNDBERG








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Clutch/Engine noise 200

    Did you replace the clutch release bearing when the clutch was done? It sounds like a classic case of a shot release bearing.
    Make sure it's not the heat shields or anything else external- then unfortunately it sounds like you'll have to go back in to replace this.
    --
    Rob Bareiss, New London CT ::: 86 244DL, 87 244DL, 88 744GLE: 625K total







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.