Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2012 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveshaft diameter question 200 1990

Any way of telling what diameter is the driveshaft on my car? I need center support bearing, but they sell two sizes; 1.75" and 2". Do I just measure it using callipers?

TIA!
SM
--
90 BMW 325is, 98 BMW 528i, 90 Volvo 240DL








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Driveshaft diameter question 200 1990

I installed a center support bearing on my '86 245 last fall. It took the larger bearing. My supplier said the smaller bearings were used on the earlier cars, around '79 or '80 or thereabouts.

In your shoes, I'd get both and return the wrong one.

Examine the foam rubber "donut" at the same time. They sometimes crumble with age.

"Do I just measure it using callipers?"

Essentially, yes -- you'd measure the ID of the bearing, which is a press fit over the machined OD of the splines.
--
Don Foster (near Cape Cod, MA)








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveshaft diameter question 200 1990

If you're buying it locally get both and return the one you don't use. Just in case your measurement is off.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveshaft diameter question 200 1990

See http://www.ipdusa.com/ProductsList.aspx?subSubCategoryID=307.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.