I have everything to do a conversion from auto to man on a 122 except for the tran brace and propeller shaft. Anyone know where I can get them from a yard or used. Thanx

Contact Joe Lazenby at Susquehanna Spares, he has just about every 122 part imaginable along with many complete cars. He is located in Carlisle PA

Phone 717-249-0565 or 717-921-2644

I understand that the automatic to manual conversion on a 122 is very difficult. The auto and manual 122 bodies have different floor pans.

Have you considered this problem?

Paul

It's not that bad...
on mine I made new rear mounts and welded them to the body, and just reused the auto rear support. Driveshaft off a 240 worked on my car with some flange swapping, and that was about it.
Oh, yeah, ya gotta cut a hole for the shifter!
Perversely, it's a different tunnel, but the bracket to hold the clutch tube's there! Go figure...
t

I did it to a '67 without any problem. Manual crossmember fit fine.

Noticed from your previous post that you gave up on the auto., good choice. The trans cross member is really just a piece of flat steel with a 45 deg., twist in the middle. You could make one with a bbq and some and an anvil. Barring that, try Stephan at www.volvoworld.com, the part will be cheap, just shipping.. Also the d-shaft, any tranny shop will shorten/lengthen yours. That being said thw easiest is another donor car. Where are you?