Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Stuck Oil Trap 200 1989

posted by  someone claiming to be Mike on  Mon Dec 8 01:17 CST 2003 [RELATED]

I removed the two 13 mm bolts and the flame trap, but something is preventing the oil trap from coming out.

Any ideas?







  REPLY TO THIS MESSAGE    PRINT   SAVE 

Stuck Oil Trap 200 1989

posted by  B.C. on  Mon Dec 8 07:21 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

The bottom of the oil S-box has a little flange that sticks down into a hole in the block. The box must be lifted and then pulled out.

OR, it may be just stuck onto the block tightly. Are you replacing it? If yes, use a thin flat-tip screwdriver between the block and the box, and gently pry it up. If it cracks the box - well you were replacing anyway, right? But- be careful to keep any little pieces from falling into the hole and thus into the oil pan.

Good Luck,

Bob

:>)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.