Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wagon hatch lock cylinder removal - anyone done it? 700 1991

posted by  Heat on  Mon Apr 12 17:20 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 26 05:27 CST 2007
[RELATED]

I've never worked on this part, but is there an "e-clip" that needs released?

I've got a Haynes manual for the 940, '90 through '96. If it is the same, here are the instructions:

Tailgate lock - removal and refitting.
1. remove the tailgate interior trim panel (another section)
2. disconnect the link rods from the exterior handle, the lock cylinder and (when applicable) the lock motor.
3. remove the exterior handle / number plate light assembly, which is secured by two screws and two nuts. Disconnect the wiring.
4. the lock cylinder and levers can now be removed afer releasing the E-clips and locking plate.

Refitting: refit by reversing the removal operation. Adjust the exterior handle link rod if necessary to give the handle approximately 3 mm.

There are no illustrations. I have no idea if the 700 and 900 series use the same lock assemblys. I assume they would, but I have no idea.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wagon hatch lock cylinder removal - anyone done it? [700][1991]
posted by  Allanwayne  on Mon Apr 12 16:24 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.