Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Broken stalk (turn signal) 900 1994

Has anyone had any luck using JB weld, Or should I just replace with a factory switch?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Broken stalk (turn signal) 900 1994

    I would get a replacement. JB weld or GOOP may work, but when is it going to break again? Not during rush hour I hope.
    Try the glue (it needs 24 hours to set right) and wait for a new one to come in the mail.
    --
    95 854T, 88 780, 88 245, 01 A4 Audi








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Broken stalk (turn signal) 900 1994

    I had the same problem. I didn't bother to try JB Weld. You can get a used replacement switch delivered to your door for under $40 via http://car-part.com/ and select "Column Switch" for your model. That's what I did, and I haven't had any more problems with it.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.