Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2015 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rumbling when turning and accelerating 200

My '87 245 w'auto tranny started a deep rumbling noise when I turn right and accelerate, leaving a neighborhood, etc. Once I straighten out, or if I'm not turning 90 degrees, no rumbling. I think this started right after I changed by oh-so-squooshy tranny mount. Could something be out of alignment of is movement that was absorbed by the squooshy mount no being forced on something that is making more noise? I know my motor mounts are shot, are these an obvious culprit. Just wondering what I'm missing. Thanks everybody. --Matt
--
1981 Volvo 244 GL w/ 225K Original B21F and 3spd. auto








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rumbling when turning and accelerating 200

I don't know about the cornering rumble- but if the car is shaking on acceleration check the driveline center bearing and mount.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rumbling when turning and accelerating 200

Rumbling on cornering in one direction is usually a symptom of wheel bearing problems, at least if it's not just on acceleration. If it is the bearings, I think it should be unrelated to acceleration and you should notice a change with speed.
--
'81 GLT 245 W/245K; '83 DL 175K








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Rumbling when turning and accelerating 200

Aside from the improbability of the coincidence, I would strongly suspect the differential. I had the same symptoms when I chipped some teeth on the small crown gears - combination of abuse and lack of lubrication. Cornering is where it's most noticeable as that is when the wheels are rotating at unequal speeds and causing rotation of those gears. Since this is a rather involved job, rule out the motor mounts first - it MAY be something as simple as the exhaust contacting some part of the undercarriage now that the back of the tranny has been lifted since the engine will now be tilted more than before (back higher than front now). Lift the back of the car and ideally, disconnect the driveshaft at the diff. Rotate each wheel while blocking the other one, and feel for grinding or roughness. If there is, start by changing the fluid in the differential, but if you see metal splinters in the fluid or on the magnetic drain plug it's probably time... Try it anyhow, if it gets progressively worse then you'll need to do something about it, simplest may be changing the entire rear axle - if ever you wanted to change rear end ratio now's the time... Mine, however, lasted thousands of miles without getting worse. I changed the whole thing because the mounting tabs for the torque rods rusted off the axle housing. Love the Canadian east coast winters...

-Chris







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.