Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How I fixed a check engine light (codes 2-3-1 / 2-2-1) - lean/rich condition ('94 945t) 900

posted by  Chris W on  Thu Nov 17 23:51 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 20 10:15 CST 2011
[RELATED]

I was driving to work yesterday morning --- first real cold snap of the season (30 degrees). About 15 minutes in to my commute and at about 70 mph the check engine light came on. Car wasn't running much diferently, other than a slightly jumpy idle. A few weeks ago, I pulled the throttle body and cleaned it, and reset the old TPS (throttle position switch) to fix the dreaded idle see-sawing.)

Anyway, after pulling the codes at work, and then trying to reset that --- didn't reset --- I drove back home. After scouring the FAQ (LOVE THAT THING), found a nice little writeup in the tune section about the MAF - and how lean/rich conditions might be caused loose connections around the air filter/MAF area.

Sure enough, the air intake hose that goes from the MAF outake to my turbo intake had slipped off (turbo side) about 1/2 way. Pulled the hose, cleaned the oil/gunk off the hose, and reset the clamps. The codes still wouldn't reset, so I pulled the neg cable for a few minutes.

Now, all is good. No more codes / check engine light. Idle seems nearly perfect. ChrisW







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.