Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2001 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tappet Replacement for 94 960 Wagon 900

posted by  Dave77 on  Sat Nov 26 08:37 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Anyone with experience replacing the tappets (hydraulic lifters or cam followers) in the 1994 960 (B 6304 G) engine. My main concerns are as follows:
1) In removing the top half of the cylinder head to expose the camshafts & tappets, the manual recommends using a couple of tools that allow the to cylinder head to come up evenly. I would think you could just remove the hold-down bolts a little at a time to accomplish the same thing. they also want you to use these tools to push the head pieces together before securing with the bolts. 2) Will I be able to pull out the tappets using a suction cup, magnet, or just a pair of pliers? Your comments and anything else I should be aware of will be greatly appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tappet Replacement for 94 960 Wagon [900]
posted by  Dave77  on Sat Nov 26 08:37 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.