Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

AMM idle setting - no flash 200 1986

posted by  someone claiming to be TomM on  Sun Dec 4 20:03 CST 2005 [RELATED]

Okay, I set-up the LED config in FAQ to adjust the AMM (1986, 240, B230f). (I already set idle speed.) I connected the LED to the test connector (next to IAM's connector) and 12VDC and no flashing. LED appears off. Grounding LED pin = bright.
The AMM on this car had had the pot plug removed so it may have been adjusted before. Any ideas why it wouldn't flash at all? The car runs okay, idles a little rough. It was hoping adjustment would smooth idle.
(Unplugging AMM (car off) made idle much worse.)

Thanks to all on the board,

TomM






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM idle setting - no flash [200][1986]
posted by  someone claiming to be TomM  on Sun Dec 4 20:03 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.