Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cleaning hubs for new rotors 700 1990

posted by  squeaks on  Sun Jan 8 06:36 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 19 20:10 CST 2008
[RELATED]

The FAQ says for the hubs to be shiny clean where the new rotor contacts the hub. I'm afraid of taking off too much metal. The FAQ suggests a wire cup brush. I couldn't figure out how a wire cup brush could get the inner part of the hub up next to the bolts, so instead I got a copper wire brush and went at it with that. I'm wondering if I did a good enough job.

Would a dremel work well on this? I have a grinding wheel attachment. I also could try sandpaper. To me the surface seems fine. There definitely is not any rust chunks of any sort. Only some residual 'dirty' areas. Whatever is there does not come off with brake cleaner.

Here are some pics:

Hub(no camera flash)
Hub(camera flash)

Thanks,
Nathan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cleaning hubs for new rotors [700][1990]
posted by  squeaks  on Sun Jan 8 06:36 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.