Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

AMM adjustment/replacement 200 1984

posted by  laharview on  Wed Jan 18 16:05 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 7 15:38 CST 2014
[RELATED]

On of my 240's has always been a bit slow on the hills. I have checked the search engine and think the AMM may be the cause. I have blocked the airbox hot air intake because I think the thermostate was bad (this was already done on my other car).

I disconnected the harness and hooked an ohm meter to pins 12 and 36. If I am reading the meter right, I get 110 ohms (not 300-380). I have turned the adjustment screw 8 turns in each direction with no change on the meter. On pin 7, key on, engine off voltage is 1.6, at idle-2.8, at 3500 rpm-3.5 and 12v or better at pin 9.

QUESTION; I think the AMM is bad, have I missed anything? Art B. is it possible to replace any components in the AMM or is it best to replace the complete assembly? What is a good source for a replacement AMM?

Thanks for any assistance.
--
1984-244 GL with 192K and 1984-244 GL with 260K, 67 Mustang and 62 F- 250 4x4






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM adjustment/replacement [200][1984]
posted by  laharview subscriber  on Wed Jan 18 16:05 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.