Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 front seat support grid, how-to bend side wires 200 1984

posted by  squeaks on  Sun Jan 29 19:11 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 19 20:10 CST 2008
[RELATED]

I am at the end of swapping seat cushions from passenger side to driver's side, and as a final test I sat in the seat. After just a bit of bouncing I heard a couple of the springs undo themselves and am left wondering what I can do to get them to stay on. I had put a little bend in the end of the side wire to prevent this, but the whole wire turned 180 degrees so the bend let the spring slide right off.

What can I do to keep the springs on?
Thanks,
Nathan

Here is a diagram of how the side wire looked after turning around:





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 front seat support grid, how-to bend side wires [200][1984]
posted by  squeaks  on Sun Jan 29 19:11 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.