Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

vibration possibly from propshaft after fitting standard shocks. 700

posted by  mintchaser on  Wed Mar 8 09:00 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 24 12:28 CST 2010
[RELATED]

After digging around the boards archives,I think i might be having some of the problems associated with the rear of my 760 gle being to low, after fitting standard shocks.
The shocks that came with the car were monroe adjustables.I dumped them because they were causing an horrendous rattle.
The back end does sit noticeably lower than the front.Ive measured the rear clearence from the centre of the wheel to the arch at 14 inches,the front measurement is 16 inches.
Should I think about shimming the propshaft centre support bearing to try get around this problem or go ahead and fit springs from a 740?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New vibration possibly from propshaft after fitting standard shocks. [700]
posted by  mintchaser  on Wed Mar 8 09:00 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.