Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Gauge wiring 200 1992

posted by  fpeck1948 on  Fri Mar 31 09:33 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jan 27 08:46 CST 2013
[RELATED]

I am installing a volt and oil gauge in the two spots left of the radio. No wiring came with them and I have a some questions:

IS THE BELOW RIGHT

All upside down T’S go to ground?
I am connecting both upside down T's together

All +'s go to fuse number 1?
I am connecting both +’s together

All lighting go to brown lighting wire?
I am connecting both lighting together

I am not hooking up the oil sender as yet, just installing the gauges, but when I test the gauges the 5 bar pegs all the way to the right anyway. Is this normal since I dont have the sender hooked up yet. I have the wire installed on the gauge and run throught the firewall, but have not yet installed the sending unit. Will this do any harm to this 5 bar gauge until I get the sending unit intalled.

Thanks
Frank





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Gauge wiring [200][1992]
posted by  fpeck1948 subscriber  on Fri Mar 31 09:33 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.