Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bypassing Sedan Rear Lights Circuits Board 200 1981

posted by  someone claiming to be 81242DLB21FCA on  Wed Apr 5 08:40 CST 2006 [RELATED]

It probably was not my post you saw but I bypassed my circuit boards many years ago. The tabs on the bulb sockets will accept standard 1/4" female spade connectors. I then used snap on wire taps to run a jumper to each wire on the connector. The socket terminals toward the edge of the light assenbly are grounds so I daisy chained all those togather and connected them to the ground wire.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bypassing Sedan Rear Lights Circuits Board [200][1981]
posted by  someone claiming to be 81242DLB21FCA  on Wed Apr 5 08:40 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.