Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intake Manifold 900 1993

posted by  JPerkinson on  Fri May 5 03:57 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello-

I've got a '93 960 B6304 Auto Wagon. I've got two questions regarding the re-assembly of the intake manifold and fuel systems.

1) How necassarry are the 'volvo' hose clamps used on the six intake hoses? Am I going to regret it if I use standard off-the-shelf hose clamps?

2) When reassembling the fuel injectors, There were smaller rubber seals that fit in the rail. When I disassembled, some injectors stuck in the ports and some in the rail, resulting in a few seals falling out. I assume that there should be only one seal per fuel injector installed in the rail. Is that correct?

Thanks
-Jim P.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake Manifold [900][1993]
posted by  JPerkinson  on Fri May 5 03:57 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.