Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

temperory ignition switch bypass for coil 200

I have a friend who's car I have been maintaining (84 wagon) and it has died in an inconvienent place. I replaced the ignigion wiring harness a few weeks ago because it had a no apark condition. Now the problem has returned and I have determined that it is the power from the ignition switch that is the problem. I have procured an updated wiring harness as I knew his harness had problems, but I need to get it from point a to point b before I have time to replace the harness. Is is possible to jumper the coil directly to the battery temporarily to get it home and then disconnect it when we get there? I have looked at the wiring diagrams and there does not seem to be resistance on the ignition circuit.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New temperory ignition switch bypass for coil [200]
posted by  someone claiming to be landlockedsurfer  on Sat May 6 17:29 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.