Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 front still sagging after replacing all suspension components 200

posted by  Daryl on  Mon May 22 02:50 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 31 14:18 CST 2013
[RELATED]

After replacing coil springs, struts, and bushings the front driver side of my 240 sedan is still an inch lower (measured at wheel well) than the passenger side. This is the same as it was before the upgrades. Anyone care to speculate why this is? And what can be done to correct it so the car will sit level for a change? Is it possible that the whole car is twisted....? There is no sheet metal distortion to verify this is the case.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 front still sagging after replacing all suspension components [200]
posted by  Daryl  on Mon May 22 02:50 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.