Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What's the deal with parts compatibility? 200 1981

uid 24778's pic
posted by  khanawalt on  Wed Jun 7 12:11 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Dec 6 21:03 CST 2007
[RELATED]

My fuel pump started acting up (bucking, snorting) so I ordered a couple of used pumps from Blake's Small Car Salvage near here and had them shipped to me. I went to install them today, and the main pump for under the car that they sent was labeled '82 Turbo 240. It had the wrong size fitting, so I cut the old hose between the accumulator and the pump off and even the barb fittings were not the same size. So I scrambled around parts stores and finally found a barb fitting at ACE Hardware that I could use in my modified fitting. So I installed it and it started fine.

On to the in-tank pump. This one was so wrong that I can't modify it to fit, so I have to run down there, about an hour's drive, take my old in-tank pump back for an exchange so I can get the car running again.

Sheesh, these cars have looked the same for what is it, 20 years? And I can't get parts that fit? I'll ask if I can get my shipping back, since I had to go down there anyway.
--
Kenny H Three SUVs, two cars and seven motorcycles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What's the deal with parts compatibility? [200][1981]
posted by  khanawalt  on Wed Jun 7 12:11 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.