Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2009 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

WHEEL(RIM) WARPED 444-544

Hello All

The front right wheel(rim) of my PV is a little warped and so I have had trouble getting it balanced(wheel balancing).
1. Would it be ok to put that wheel(slightly warped) at the back and move the one at the back(balanced wheel) to the front.
2. Will the rear wheel/rim(slightly warped) then cause any problems considering it is hard fixed as opposed to the front wheel which has free movement for obvious reasons.
The reason I am asking is that the car is pulling to the left a little. The brakes are fine as when I brake hard the car does NOT veer to the left or right. Therefore, I believe that I need to to make sure that the front wheels are correctly balanced before I can see correctly how much the car is pulling to the left.
Once the two front wheels are balanced and the car pulls to the left then I can worry about getting the front wheels ALIGNED(caster/ camber/ toe-in/ toe-out).

CAN SOMEONE PLEASE TELL ME THE CORRECT(OPTIMUM) CASTER,CAMBER,TOE-IN,TOE-OUT AND KING PIN INCLINATION FOR A PV544(1963) B18A. I WOULD REALLY APPRECIATE IT.

SUNIL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WHEEL(RIM) WARPED [444-544]
posted by  HINDU544  on Tue Jun 13 01:53 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.