Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Why cant I REV anymore? 700 1991

posted by  snow_k2 on  Wed Jun 14 17:19 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I replaced my timing belt; I had it re-checked to see if it was on tooth. I had my distributor and rotor and plug wires replaced. Yet, I still can’t rev beyond 2,000rpms with the foot on the break and on drive. My vacuum is about 13inhg idle (the normal was 20inhg idle). What’s wrong? Vacuum leak or something else...I cant find it anywhere.

I can rev high in park or neutral.

car is a 91 740t, aw71, boost at 10 psi, blaster 2 coil, NGK Iridum IX plugs, new distributor and rotor, new wires, catch can connected to PCV system, new AMM, K&N cone filter with a nifty heat shield around it, most vacuum lines have been replaced with exception to boost gauge line, and the large vacuum line which is connected to the vacuum check valve.

Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Why cant I REV anymore? [700][1991]
posted by  snow_k2  on Wed Jun 14 17:19 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.